![]() ![]() Secondly I really like the X-touch after setting it up correctly. While I put money aside for an upgrade having such a controller helps me solve this issue. Due to this I can't have the mixer open at the same time as the main window or other such configurations. I have a very bad computer with a small display. Makes recording volume automation easier and more precise The touch and latch buttons don't seem to work.Ģ. ![]() It should be just left of the write button. Good luck and happy production!Įdit: if you end up having the issue that the faders are constantly resetting despite you changing the values, make sure the "read" button is selected on the X-Touch. If you are still stuck, let me know, maybe I can help you out. Hope that this helped you set-up your device correctly. This should fix any glitches you experience when recording volume automation or touching any buttoms. This will prevent you to trigger various CCs or notes everytime you touch your X-Touch controls. Make sure to unclick that box for both INT and ENT inputs. You should see a box that is ticked on the right of each input in the colon reading "In 'All Midi input'. You should see the list of midi inputs and outputs you have currently connected to your computer, go to the yellow region which are the inputs and look for X-Touch INT and X-Touch ENT. In the Studio Setup window, go to "Midi Port setup".I only learned about this important step by going through Cubase's external Mackie control setup guide in the manual. This is because in the setup video by Behringer, they forget to show this. This is what I didn't know when I was setting up my X-Touch and which caused me to think it is broken. Now that the Mackie Control device input is set up, you still need to adjust your Midi, otherwise you will experience glitches and hear notes everytime you touch your X-Touch.If you are in a project and nothing happens, you did something wrong. Your X-touch should immediately set its faders to the values of the project you have selected. Once you have selected "X-Touch INT" in the two boxes, click "apply" in the bottom right of the window.Make sure both read "X-Touch INT", otherwise your device won't work. On the right you should see two dark boxes reading "Not selected" there you can select your input and output for your Mackie Control device.A new device should now be visible under the "Remote Devices folder" of the "Studio Setup" window called "Mackie Control", click that.A list of devices should pop up, look for "Mackie Control" and click that.Go to the top left and click the "+" sign. A window called "Studio Setup" should pop up.Once you are in Cubase go to the "Studio" tab on the top left of your screen and then click "Studio Setup." which should be the lowest choice that pops up ( see pictures).Now that your X-Touch or other device is in Mackie Mode, open Cubase.This button saves your config and once you click it the LEDs should read nothing and the sliders should reset to their lowest position. That button should normally be illuminated green. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |